Friction press is a kind of pressure processing machine with strong usability. It is widely used and can be used in various industries of pressure processing.
Friction press has played an important role in the development of industry since it came into being. In order to standardize its operation, it is necessary to pay attention to the following procedures:
1. Wear and wear protective equipment.
2, comply with the general safety technical operation procedures of shearing and punching machinery.
3. Before mounting the die, the closing height of the die must be checked. Only when the closing height is within the allowable range can the die be installed, and the upper and lower travel of the punch must be adjusted.
Keep it within the prescribed safety limits.
4. When installing the die, it is necessary to align the hole of the die handle so as not to gnaw the hole edge when the slider falls. The area of the formwork should not be too small to avoid collapse
On the die.
5, when using jacking, the length of both sides of the tie rod should be adjusted consistent, not skewed.
6. The process of starting the equipment is to start the oil pump (or open the compressed air valve first) and then start the friction wheel motor. When parking, on the contrary, should first close the motor driving the friction wheel, and then close the oil pump (or compressed air valve).
7. When working, pay attention to whether the oil pump pressure or compressed air pressure is normal.
8. Machine adjustment or mold installation and other work are not allowed when the flywheel is rotating.
9. After the work is finished, the punch will fall smoothly and close the car in order.
The above is the general operation rules of friction press.